What to do when your Mac can’t mount, repair, or erase a drive October 27, 2017 Iphone Macbook 28 Reader Haris wrote with a drive problem: “My Samsung SSD stopped working suddenly earlier today. Couldn’t boot and couldn’t repair it in Disk Utility.” Haris had kept his 2012 MacBook Pro’s original hard drive, so he swapped it in place, and it wouldn’t boot. He couldn’t erase, it either: “The bar loads, but it just keeps loading and the ‘estimated time’ just keeps increasing. It’s about halfway. I waited several hours and the time still keeps increasing.” I’ve had many hard drive—and more recently, SSD—failures, and in most cases they won’t get to this state if the drive is bad. I suspected that it was a linkage between the drive and the laptop that was at fault, and suggested Haris try to swap the cable. He wrote back: I bought a new hard drive cable and then the problem was solved. It seems that the MacBook Pro from 2011–2012 have some issues with the hard drive cable failing after some time. A Macworld article from 2013 by Chris Barylick cites cable failure as one of the most common problems he saw working at a university-run tech-repair shop. I’d had my own problems over a year ago, when a not-very-old Mac mini seemed to go berserk. It wound up seemingly destroying external drives and its internal one, possible because of a failed drive bus, as it affected multiple kinds of peripherals. I replaced it with a new Mac mini, and all the problems went away. Ask Mac 911 We’ve compiled a list of the most commonly asked questions we get, and the answers to them: read our super FAQ to see if you’re covered. If not, we’re always looking for new problems to solve! Email yours to firstname.lastname@example.org including screen captures as appropriate. Mac 911 cannot reply to email with troubleshooting advice nor can we publish answers to every question.